View Full Version : General DSM Tech and Tuning
- Riggin' up H2O injection/Pump ideas?
- Need S-AFC Settings 97GS-T
- AirFilters opinion
- Newbie here just wanted to say a few things and ask a few questions.
- sticky brakes
-
- Oil covered...
- Charcoal canister: I need an answer
- 97-99 front bumper cover,please help
- egt/temps-vdo/greddy
- Need a QUICK REPLY!
- how hard is it to replace motor mount near battery?
- 1G BOV venting to atm sounds strange
- New exhuast= Service Engine Soon light
- S-AFC settings, help!
- Looking at a 1gen GSX... Is this car a basket case?
- Factory Tach Accuracy??
- HELP! Wrong Radiator? pictures included
- stupid idea for leaning out
- 20 psi
- 20G Turbo Help asap
- Messing with the ignition timing curve. Is it worth it?
- How do you tell the difference between a 1G 7bolt & a 2G 7 bolt engine.
- It's started!!! :) Engine rebuild/build up.
- A/C Recharging
- What is that thing behind the radiator?
- ?'s about a shortblock for sale
- 2G SMIC CFM??
- On average, how much oil is lost between oil changes??
- 1G BOV questions
- Is it physically difficult to replace the coil pack?
- Is it physically difficult to replace the cmashaft position sensor?
- Pics of Thermal on 1G
- A/C recharge
- 6 bolt to a 7 bolt
- Sparkplugs & Wires
- looking for CAZZO..need safc help
- Broken axles
- anyone here have a T60-1
- AC on ='s idle jump
- oil and temprature guages
- UIP's questions....
- Turbo inlet rubber spacer
- BOV Question!
- Flywheel Bolt Torque Specs Question
- How can I permanently remove my ABS?
- For anyone with knowledge of Turbos and Boost Controllers
- What do I need
- Serious trouble....timing belt has skipped!!!
- changing the motor mounts
- Greddy TVVC
- Why faster spool up with a manual boost controller?
- What causes studdering or hesitation?
- Can someone tell me the bends I need for UIC piping?
- Where to get tne J-Spec?
- HELP! third downpipe still dosent fit..
- Whats the best clutch for 2G AWD??
- How do you install a turbo timer?
- when did DSM's go to OBD-II?
- Someone with a Profec B give me some feedback
- Would one of those huge HKS bov fit on a stock 1G?
- A ? about standalone ECUs.
- 1g transmission install
- how long a stock turbo can last??
- Dejon Tool IC piping
- throttle position outputwire???
- fuel pump wiring
- When does porting/polishing the 1g head become effective?
- Bypass I/C for troubleshooting?
- New PCV Valve???
- Intercooler(pic inside)
- Buschur Intercooler
- 2nd gen
- Internal or external wastegate
- 30 psi?
- Milemarker 120...
- awd vs fwd
- 1.8 Flex pipe question..
- How big can the intercooler be?
- TRE FRANK 3.ANYONE RUNNING ONE?
- Puffin a little blue
- How do I remove the front face on the block?
- a/c compresor belt
- more power
- mitsubishi eclipse, JDM?
- Oil viscosity and temperature?
- how do you change the steering belt?
- Anybodys 1G ecu just quit on them?
- Clutch/Tranny Problem *** Please HELP!!!!
- Is 17psi safe with my mods?
- which engine?
- does anyone know what a 2g tranny looks like??
- hard starting and idle problem
- Whats the most I can expect from my T25?
- ? about double clutch (not what is it)
- Crankwalk test
- notchy shifting
- 2G Datalogger- What are my options?
- Sooo Confused! Please Help! About filters
- help needed asap on oil filter
- fake catalytic converter
- what do the hp ratings on turbos mean?
- 16G/Super60?
- Whats the best place to buy a built engine/ stroker engine????
- FULL 3" exhaust, what are my options
- 32k Stk flywheel OK with new ACT 2600??
- t28/28 or 14b??
- Is 2g worth it?
- whats the deal with Lightened STOCK flywheels? Is it junk??
- hahah, listen to this
- Hella H4 upgrade (89-91 DSMs)
- Oil in da intake...
- transfercase question
- ECU question
- Homemade dent remove
- HKS SSBOV w/ recirculation kit sound??
- in need of fuel what to do?
- What Restricts Gas Recirculated to the Gas Tank?
- gaskets: look!!
- 2g o2 housing on 1g
- 3" exhaust system for $3.99?
- Does the Thermal 3" GSX exhaust sound different then GST Kit?
- ? ABOUT MBC
- Adjusting GReddy S-Type?
- Fuel Pressure Gauge Install???
- What do you think I should get?
- 4g63, what makes it so good?
- whats the big deal with head gaskets
- IS THIS A GOOD WAY TO GO?
- intercooler pressure drop survey
- new to board...searching for a GSX...please advise =)
- If you remove the turbo off a 4G63 and...
- How do I get the oil dipstick tube off?
- HEY guys with 1990 DSMs
- I/C sprayer post got me thinking.....
- hmm, I didn't know a clutch could go bad in 1 month....
- 91 GS-T
- I need help fast, my car stumbles when boost kicks in
- Changing valve seals in car (1G-T)
- Where can I get a mild $$$ exhaust???
- unmetered air idea...
- Anybody have the pinout schematics for a '90 FWD turbo eclipse?
- which voltage reading on the SAFC is the right one for A/F ratio?
- Crushing BOV
- Help with rear diff setup
- High or low comp. pistons
- msd ignition wires
- New cam shafts........
- "ECU"...."PCM"...same thing?
- Racing Harnes
- repair manual
- towel in my rear cam gear under my belt, , yep
- Who is running this brake combo?
- Boost Problems?!?!
- boost problems!?!?!
- Oil Leaks
- Greddy Profec B .. More Boost
- Can I do this???
- My temperature gauge is dead, help please!
- homemade intercooler
- my car = SLOW!!!
- ACT 2100 Power
- Can you mount 60mm gauge in the cigarette lighter?
- 1G NT parts on 2g
- need parts for custom MBC
- 2 quarts of transmission fluid resulting in grind?
- how much should this cost?
- is there a TPS on eclipses?
- Need a source for a turbo rebuild kit
- A/C stuff!
- what does a 6k clutch dump hurt the most?
- Plan of Attack for DIY IC Pipes
- Removing paint from the intercooler
- ECU help
- Quick valve cover question?
- how to tune with 100 octane? up boost, lean out, what?
- eclipse modif
- AWD driveline loss, much higher then I thought
- power loss and problems with leaks???
- anyone heard of this??????
- HELP ME WITH MY DECISION plz?????
- big 16g or 20g, what to run if I don't plan on going over 18psi ever
- studder and no boost
- shot Pistion...
- Steering Fucked.
- turbo lifetime
- Why do I still have knock? (Long Story)
- Joe P Q's On adjustment screw
- 550's
- Best way to fix boost leaks?
- Autometer gauges
- Can a turboback exhaust make your car run like crap?
- Boost Levels
- Making my own 3" exhaust
- How to....
- Year of the 1g
- my car was no faster in the 1/4 with ported parts
- emissions / quaife's / Boost leak?
- 1st gen turbo (automatic)
- scatter shield
- Quick question for you 2G's
- I NEED HELP
- 16g, 18g flow?
- Knock only in 4th?
- Will a 7-bolt tranny fit in a 6-bolt car
- fan shape for condensor assymetrical?
- HID Conversions, anyone try it yet?
- Galant engine swap?
- which one, dynomax super turbo or dynomax magnum racer, also 3 or 2.5?
- weird lifter tick fix
- 1st gear power loss?
- tapping manifold
- drive shaft boots leaking??
- Homemade Intake Pipe?
- Buschur Exhaust, I NEED A RESPONSE QUICK
- hey mitsu techs: "adjusting ISC"
- pulley thing your belts go on
- 2g BOV on 1G
- 5th injector
- Steel mesh radiator hoses
- Can't get more than 10 PSI anymore
- How do I find boost leaks?
- steel clutch line
- important, please help
- replacing the tranny....
- AC clutch
- Which turbo is right for me?
- If I polish my 1G BOV, will it rust? I don't like the army green color: )
- Is it possible to port exhaust man. with dremel?
- APEX S-AFC
- NEED HELP!!!!!
- Intake Air Temps/ Heat Shielding
- Vortech boost dependant fuel press. reg.
- Headlights
- Key won't go in!
- Will a boost controller help?
- Will these work
- 1000 RPM idle, good or bad?
- Goddamn tick, what the hell is that?
- Crankwalk? Help me out please?
- Copper Manny Gaskets Need feedback!
- Just ordered my B&M Shifter from RRE.......
- Clutch bolt question
- idle went up??
- stupid me (clutch and alternator related)
- Has anyone had their clutch pedal stick when turning left?
- S-AFC settings for faster boost?
- To weld or not to weld??
- I was thinking about buying one of those
- Please Help
- anyone with mitsu. part lookup?
vBulletin® Copyright ©2000-2009, Jelsoft Enterprises Ltd.