View Full Version : General DSM Tech and Tuning
- Yet another lifter question (3G)
- Need Opinion on FMIC
- approximate fill location for 134a gas on a 2G turbo?
- cliping a 14b?
- What can I run for PSI?
-
- Wheels spinning in neutral?
- Is it possible to use a apexi ebc for tuneing?
- Moved from Help!: Boost but.... no boost.
- Does this sound like a leaky head gasket?
- 4 spider diff, yes orno?
- rear b-shaft bearing
- NGK plugs...I know..
- ok, whats up with my BOV?
- anyone in here tuning with a ramchargers maft?
- Picking a Block
- High boost feels like low fuel cut.
- 92 6 bolt engine into a 90 shell
- L2R or rebuild motor first??
- What injectors do I have?
- 2g Alt. Belt Problem/Fixes
- my car just started smoking bad.??
- Working on engine swap: opinions wanted
- Supra SMIC and 20g
- Gas smell
- Removing Crank Pulley and Harmonic Dampener
- Fuel Pressure drop...but why?
- New Creep
- Mass Air Flow Sensor
- Mixing different fluids for injection
- SRS LIGHT!!! make it go sway~~~
- Oil Pump clearances
- Engine Removal (Non Turbo) - Tips to share?
- Cost to replace power steering lines?
- Air/Fuel Gauge not moving up and down after maft install
- Smoking value cover
- Calibrating Boost Gauge
- clacking noise from1500 to about 3k
- Fastest 14b Powered 2G AWD?
- Crunchy Clutch
- The truth about JBWeld and fuel??
- Blue filter oil on k&n
- new tranny or no?
- squishy sound from clutch peddle...
- New logs...correct me if im wrong.
- why would a turbo backplate lock up?
- Anyone sleeved their motor?
- Mild Rebuild (don't want to clutter the sticky)
- Homemade Revised Lifters??????
- Riddle: What feels like fuel cut at only ~60%DC (injectors)?
- Air Temp ?
- Greddy Bov
- few questions about 6 bolt in a 93..(fwd to awd)
- help me on diagnostic port diagram
- Launching the FWD
- manual boost controller install?
- Good compression with bad timing?
- True or False??...about fuel pumps
- 2g CAS trigger position
- Do I really need a third gauge?
- 14B install on a 2G with a homebrew install kit
- What is the sensor on the M/T that is about 5 inches left of the shifter cables?
- BOV problems? Throwout bearing problems?
- 180 degree thermostat, and AC fan trick, just curious about these mods
- rollcage installation question
- Are center diffs the same from 1g to 2g AWD
- Need welding help!!
- Wierd high rpm problem
- Front balance shaft sprocket?
- Need info ASAP! How do I run A/C fun without running A/C?..
- MCCC vs Amsoil Engine Flush??
- car stalling at 14psi or higher
- 1G Throttle body-> 98/99 Turbo, how do I get the EGR sourced properly?
- supporting motor without oil pan?
- Which repair takes longer to get the job done...
- Clutch break in
- Urgent SAFC q?
- coolant light. but coolant full. + low oil psi @ idle?
- Manual Steering Rack for 2G?
- What are the torque specs for...
- 02 eliminator, how to wire?
- What kind of boosting is this??
- 4g63 Nt to Turbo block comparison
- valve cover gasket question
- difference between dodge/jeep/mitsu 2.0l engine?
- Neat hint.
- Walbro 255Lph Fuel Pump install
- compression check results
- How does gear ratios work?
- high MPH in the 1/4??? What should i buy with for my setup
- how does a bad turbo smoke?
- Intake Manifold
- Why 16G instead of 20G?
- turning a 6 blot crank?
- PLeast help with my frends EVO hitting fuel cut
- Do I really have a 2G head?
- Replacement 2g CV Boots exist??
- Trans Fluid Leak - AWD Output Shaft Seal?
- Supra IC questions
- oil in turbo inlet!!!
- Manifold Stud Install ?'s
- Need Good Price on Walbro OEM replacement
- motor drop and rains starts to pour
- Does this sound like a bad O2 sensor?
- 2G water line Block off
- Definatly a problem HELPPPP!!!
- exaust manifold bolts
- No Karman Reading on SAFC
- boost problem
- High Flow Cat question
- external O2 dump thought and theory.
- Warning: Look out for this while changing O2 sensor.
- clutch whoa
- S-AFCII, need a little help
- First time at track with my DSM
- Help finding repair shop in Orange Co.
- Walbro install: use Zipties or Hose clamp?
- Has anyone had a VC fail??
- Complete restoration, where to start?
- Oil filter backing off!!
- Stock Boost Gauge What Is It?
- How much shaft Play is good?
- crankshaft endplay
- Cleaning up my head, any info would help.
- Taking off water pump pulley/crank pulley
- what will i run?? 18g, injectors, front mount, etc...
- 1Gina2g Starting problems.... Has worked before.
- Using 90 ECU in a 91?
- balance shaft inspection plug
- grinding into 2nd ...
- What motor is in the Talons?
- 16g install coming up...
- Weight reduction / removal database
- turboxs h-34 install questions
- Different kind of intercooler fan
- Mismatching Error Codes
- New engine. Still stutters but worse.
- Need help with my cars setup?!?!
- Emissions crap removal for 2g's
- No compression, new block, rebuilt head
- 2g tranny in a 1g
- boost controller question
- 2g tranny's all the same?
- FMIC or upgrade SMIC for FP Big T-28?
- Fuel cutoff when turning
- Can UICP cause lag?
- Emissions Help
- which sensor is this????
- How to tell a JDM motor from a U.S. spec motor??
- Weak Tranny Question
- Oil Feed Line Question
- 90 vs 91 cam angle sensor. can i convert from 90 to 91?
- two fuel pressure gauges?
- Replacing Turbine in FP Big28?
- misfire/ timing pull
- signs of a failing throwout bearing and/or a failing slave cylinder?
- oil sender wire...
- Autometer air/fuel ratio gauge owners inside
- Installing turbo outlet elbow w/o nipple?
- Installing Greddy Electronic Boost Gauge
- 170 Compression??
- Need tips on replacing a starter
- Installing 2 headgaskets?
- changed clutch fluid question
- Hacked the crap out of my 1G meter
- TPS effects question
- 2g tranny in a 90 fwd
- Help me identify my tranny
- What kind of oil is this???
- Auto Torque Vs. Manual HP
- help locating part
- Clutch won't disengage
- Phantom/partial-throttle knock question:
- Gotta love engine issues
- radiator cap - raises pressure?
- Best year cylinder heads (1G)
- Intake Manifold Gasket - How to get off? And Need RTV to put on?
- Head Questions
- Transmission Diagrams with part numbers?
- Metal shavings and rebuild question
- 2g clutch in a 1g??????
- Question about boost leak and PSI.
- Skyline BOV Flange
- Will a 2g 420a engine drop in a NEON?
- pocket logger..... question about trouble shooting with it
- What boost on 16G with the following mods...
- Got an electronic fuel pressure guage? Please read
- loud lifter tick
- Buying used big calipers worth it?
- Is this normal for a walbro 190 fuel pump?
- what will happen if i dont torque bolts down to spec? flywheel, pressure plate...
- Transfer case differences?
- Can't stop timing belt from jumping. . .
- Can I remove the stock temp sensor with aftermarket one?
- Ported 16g not pulling all the way to redline
- what size injectors??
- Greddy EGT gauge won't read temps, plz help
- Engine Noises
- valve gides
- 450 injectors
- how to remove HVAC control knobs?..
- fuel problem????
- will this fit?
- 2nd Gen MAF into 1st gen Question?
- Resurfaced flywheel (from Extreme Motorsports) dowel pins missing!
- Logged and tuned my car tonight!
- ABS piping vs Stock radiator-type hose
- stupid dis-2 question
- Car won't shift into 4th gear at WOT
- 500HP street car???
- 1G motor questions....
- 2.5" dp & exhaust on 20G?
- need some mathmatical help setting up some base AFC settings
- Finding perfect exhuast.... Help!
- Quick plug/wire firing order question...
- 3000 GT VR4 o2 Sensor in a 1G DSM
- Lower Radiator Hose for a 2G with 6bolt
- New or Rebuild?
- 1990 Engine Bay. WTH?
- Help with my logging!!
- Help me price my car
- MKIV install is a MOFO!!
- pocket logger, 90 ECU, and check engine light
- friend just got front mount w/out piping, need help installing it..
- Turbo Rebuild Shops
- Turbo Oil Return Line Replacement
- Blowing out White Smoke???
- Quick honing size question
- Why does my 93 laser have an external oil cooler?
- Tuning with DSMLink
- Steering Column Bezel
- leaning out low throttle on s-afc
- Getting Tranny rebuilt HELP!
- Intake Leak Tester.. Very easy question.
- 36mm tranny shaft nuts
- Question about vacuum readings (and cams)
- 20 psi safe?
- gettin my exhaust...
- Tranny - which spline?
- My turbo's actin up (i think)
- exhaust idea
- Evo II bearings/pistons
- Cheap, Straight Through, Non-Ricey Muffler/Tips for a 3" turbo-back
- is this worth it?
- oil dummy light flickering...
- is 190 pump enough
- Taking off turbo, is it worth it to port Exhaust Manifold?
- Just got my First Boost Leak I think??
- magnaflow any good?
- something wrong with my car
- Losing Cylinder after 6 bolt swap
vBulletin® Copyright ©2000-2009, Jelsoft Enterprises Ltd.