View Full Version : Help! Tech
- engine almost turning over, but no go
- is this the problem?
- I'm getting 0 psi on the new T3/T4 kit
- Moderators please help!!
- wet cylinder / bad oil leak
-
- No Hole for sensor on 1st gen manifold!
- Help me decide if I bent valves, or broke trans...
- Is a 1stgen CAT compatible with 2nd gen?
- 92 = 90 ?
- Valve cover blowing crapload of air; thick residue in intake piping.
- could this be short related??
- where is my oil going???
- brakes feel really spongy go to floor at times
- Am I The Only One?
- not starting!?!
- Oil warning light at Idle
- 5-spd rebuild or replacemant in PA ?
- Convert a 22 spline AWD to 23 spline HELP!
- Exhaust Leak
- Installed knock sensor and now a/f gauge reads lean always
- Converting PDB to CSV Files! MMCD Logger...
- Weird noise in back of intake manifold!!
- Fuel pump makes noise after its off 5 mins?
- Transfer Case is shot but I need help!
- whats wrong?
- What happens if the PCV doesn't work?
- Act 2600....too Much? Help
- oil inside my uic pipe and injen intake is this normal???
- 2g won't turn over
- ANTI LOCK light
- need bolt banjo bolt size, 90 oil cooler line
- turbo rebuild
- Help Please Anyone
- tack problems in 1.8 to 2.0 convertion
- At speed surging then TOTAL loss of power?!?!
- 1G Suggestions! Replacing with used tranny, grinds in 2nd!
- Wastegate Actuator Arm Help
- Need help getting my Viscous Coupler on
- Throttle Cable
- EGT temps?
- Won't start.
- Still am confused?
- Got in front end collision, turbo acting up!?
- installed new flywheel and clutch, now release piont 1/2 from floor
- The boost leak test failed on me...
- seems like no torque?
- Weird question about shofter cables.
- Help with a problem please: Injector Circuit
- balance shaft removal (not asking if, asking a specific)
- weird Overheating problem-HELP!
- anyone with a 2g gst (easy)
- spedomotor and odomoter not working
- How to get the reverse bulbs out 97 rear end.Unscrewed and they wont come apart?
- Need a Valve Job -- how much money do you think I need????
- No adjusters on 2G Shifter cables
- ANTI LOCK light again????
- 1300+ rpm idle? What could be the culprit?
- broke pressure plate to flywheel bolt
- 1st...2nd...cloud of smoke....3rd
- 2 broke axles in 2 hours
- Oil pan removal problem!!! Please help
- Tranny problem
- Clutch engagement question
- engine ticking
- How long will this last?
- Help me diagnose funky clutch issue.
- 2g mas in 90
- How much can cost new rings, gaskets, here in USA?
- I've done lots, and I'm disappointed, what's wrong?
- what went wrong with my tranny?
- just did rebuild, and it wont spool
- need help!! feels like fuel cut but its not!!
- Emissions Help! 1990 Turbo Laser
- quick question very important
- Correctly putting tension on timing belt with out special tools.
- Staring at my valves through the intake/exhaust ports.
- ISC Motor test
- Car cut out while driving at 55mph just cruising then mysteriously came back online?
- no FCKIN spark
- problems with profec b
- ideas to save money on my new project
- Replacing some valveseals this week
- Quick Tranny Caseing Help!!!!!
- Burning smell, think it is the alternator.
- CEL Airflow Sensor
- nos install!
- High Idle Check List
- Won't Start (Sorta Long)
- Clutch Pedal stuck on the floor!!
- extreme boost problems
- Oil line to the turbo broke...
- how much porting?
- Starter relay confusion
- Is this a dead 14b?
- Broken Lowercontrol arm/spindle
- Timing belt replacement problem
- 02 sensor dying?
- valve guides
- Oil filter housing threaded bolt..
- Big 16G install oil return line problems....
- help ASAP RE: bolt on manifold
- installed my new 550's and car wont start.
- Reading TCU codes?
- engine harness 90 l =92 e?
- All my wipers don't work!?!
- OK to drive car with possible bad throwout bearing?
- Need Advice From All you DSMers :)
- Turbo died, trying to fix it right.
- Trouble starting....Please Help!
- CEL p0501
- AGP L2R spools slow between shifts
- Exhaust manifold stud w/ broken off easy out
- TMOlogger??
- Fuse kicks immediatly!
- Loud chattering from timing belt area????
- New junker... wont start.
- 255lph fuel pump
- Fuel Cut, Its Pissin Me Off!!!
- Help!!!! Clutch Squeek..........
- Help with timing belt/post timing belt starting issues
- Help! O2 sensor voltage is constantly at 0.9v
- Do you think it's a wheel bearing?
- Added Mods, now clutch seems to slip...
- leak down test, need some oppinions.
- Head Gasket
- Help serious electrical problems
- Stumbles on face past 30% throttle
- Replacing HG how do you prep the block
- compression check!
- Alternator Belt slipping off after starting
- VSS Logic
- Wastegate fully open at just 5psi?! Help!
- Headlights staying on
- how to adjust BISS withot the scantool?
- Electical issue HELP!
- Need Help On Making Up My Mind
- Overheats....cant figure out why!!!
- Crank Angle Sensor Problem?
- Help with Diagnosis for blue smoke, wierd one
- Cars dead what to do???
- fried rings?! parting out TSI?
- safc tuning way to high knocks
- Squweaks when I turn left!
- No.4 injector is not working! ECU problem??? HELP!
- How Can I Make My Own CAI System?
- No oil pressure! Possible causes?
- Boost creep with external wastegate?
- Need Some Help with PALM
- Question on Timing Belt Cover(s)
- knocking sound from underneath...
- Smoking like "Whoa"
- crazy boost creep after installing supra smic and dejon tool pipes
- boost creep or stuck actuator?
- Water Pouring From Front Of The Block... Dont Think It's A Waterpump
- Overheating
- power steering leaking badly
- Starter/ Flywheel?
- Should my boost increase?
- Irregular knock light and possible bad injectors???
- Flickering CE on WOT and Punching...
- Engine Popping sound, CEL, Runs rough!
- SWEET MERCIFUL CRAP my clutch is squeeling
- Car will not start
- Help ASAP! IntakeManifold hose Diagram
- FWD clutch install questions
- pocketlogger nightmare!!!!
- check engine light
- 80 AMP Alt. Fuse keeps blowing!!!
- Guys who have put a 1G head on a 2G block, got questions
- Ghost CEL?
- Drive Shaft Seal Leak????
- Why would O2 bank 1 and O2 bank 2 read around .04-.06v?
- need turbo's turbine housing sizes. QUICK!!!
- car will not spark.. already searched and didn't find answer
- warm up woes
- Car runs fine, but a couple codes...
- Would mccc clean this? (pics)
- Idler Pulley
- 6 Bolt Swap CEL P0300 Help!
- Cel Oddity....... Help!
- My battery dies everytime I shut off my car please HELP!!!
- batt and boost problem
- fuel question.
- Misfiring
- CEL question
- Car starts missing out of the blue
- Timed out O2 Sensor
- will 95 t case work on a 1g please help asap...
- O2's low at WOT, and .0v when tap throttle
- Why low oil pressure and no idle?
- fuel cut????
- I think the dealer is trying to F$%* my friend
- Grease on new head?
- 99 gs-t with 23 fault codes
- clutch or transmission problem
- Bad alternator?
- bent axle?
- oil filter help!!
- No speedo?
- 1G fuel line replace?
- What fuse to use for Fuel pump???
- No power gains from downpipe.
- Charging woes....
- Need help w/ head install ASAP!!
- false overheating
- tranny noise. HELP!!!!
- Snow in Engine Bay
- Changed timing belt now car isnt running right
- boost dropping?
- Base Timing won't set/runs crappy
- Oil return line sealing...
- Car intermittetly stops firing on 2 cylinders
- Overheating ubder light cruise on the highway??????
- Help! I need a camshaft seal!
- busted that blasted big control arm bolt
- What's this noise?
- car cuts off when i put it in neutral to slow down and make turns
- Broken two day old car!! HELPPPP
- oil pump gears??
- injector not having - power
- Very Sucky Gas Milage
- another idle thread...
- Help Oil leak problems
- 99 GSX brake question
- Can someone tell me what nut and bolt I need that bolts the 02 housing to the turbo?
- I hate tow trucks!
- HELP, Anyone in the South Dayton, Ohio area
- tsi RWD????
- Car studders sometimes when accelerating...
- May need to upgrade entire fuel lines; input needed
- won't rev past 2k rpms and loud lifter tick
- car looses comm. with ecu
- 6 Bolt or 7 bolt???
- car staling problem
- Temprature Gauge dont reach half way mark
- could a loose timing belt cause bad milage
- MAJOR problem this morning - please HELP
- strange results after VR4 FP install?
- act2600 break-in problems
- timing getting pulled and hella knock
- Trouble shifting into reverse.
- Oil Leak! Help
- pops out of first (searched)
- Idling at 2000 RPMs when warm HELP
- tried doin an intake leak test
- flapping/knocking in 2nd gear
- Help! Knocking form inside the head
- Bad Engine Vibration
- grinding after deep water????
- Increased Pedal Travel/Soft Pedal
vBulletin® Copyright ©2000-2009, Jelsoft Enterprises Ltd.