G** D*** Tranny!

[93DSMGST]

Yo yo i have a lil prob and need some help. I have a 93 4g63 and recently put a new clutch and throwout bearing in it but it wont let me go into gear! I bleed the system and everything nessecary but when i engaga the clutch it wont let me go into gear it just grinds and i just hear the clutch spinning inside the tranny. the idle drops don a lil and just stays there! What could be the problem hit me back if anyone knows!

[7inchexhaust]

uhhhhhhhhhh..... :confused: .....i think ur in the wrong forum

[blue1]

Does it feel like you have a full clutch pedal when you press it, You did put the clutch disc in the right way around?? Did you clean the pressure plate and get the surface protection stuff off before you fitted it because this stuff is like glue and the clutch plate will stick to the pressure plate and not release.

[dsm1991_28]

Did you grease the input shaft where the tob rides on? I had a prob similar to yours and I didnt put enough lube on it. Just a thought.

[1QuickChic]

in the wrong forum man, but try adjusting your clutch pedals under the dash also you may have a bad/weak clutch master cylinder, slave cylinder