Indiglo Guage Help

[spooled92]

I'm trying to put in a set of reverse indiglos on a second gen. and the wires on the black box are cut and Ive never worked with indiglos before so I don't know to much about them. This is the condition of the parts:
Black box with 4 wires and the 6 wires to the toggle switch
the dimmer knob has no wires hooked up
The black box has no clips on it
the 4 wires off the gauges have little black clips.

Yes these are used. Can anyone help us?
:confused: :confused: :confused: :confused: :confused: :confused:

[Iceman138]

Is it possible you could post a picture of it all? My guess is that two of the wires coming from the black box go to the dimmer, and of the other two, one goes to ground and the other goes to 12V switched (with the lights)...

[curtisimo]

i have gauges from ac autotechnic. Each gauge had a wire with clip in the end and then the black box had to wires for + and ground. the control switch was a ribbon cable type thing that also lights up. im guessing for some reason the last guy cut the clips off of the 4 black box wires off. if you can ask him i would do that. i sounds like your gonna have to just try to find out where the wires go for the switch by trying them out. If you can get support from the manufacturer maybe they could email you some sort of instructions???

http://images.cardomain.com/installs/206000-206999/206575_4_full.jpg

[MaJiKTeRRoR]

what kind of indiglos are they? Sounds like u are going to have to hard wire them. That's what I did, but I did it because the wires were too short for me