Anyone got the radio wiring diagram for a 1g

[Frisco]

The dsm I bought had a crappy sometimes working pioneer tape deck in it and Im trying to replace it, but I need the wiring diagrams to make sure its done correctly. Anyone know where I can get a hold of em or have a copy they can email me?

frisco

[Frisco]

Ok i found a diagram but somethings not right....
http://se.dsm.org/1genplug.html

where is:
right front -
right rear +
left rear +

and why is there:
2 left rear -
2 right rear -

Whats up with that?

frisco

[Eben]

FYI: Save yourself some greif and but a wire harness (providing that the vehicle still has the factory radio plugs intack)

<<<If not then attempt to repair it then go get a wire harness

<<<If is totally cut out of the car then you can just use the wires and crimp on your own connections(see below)

FR = wht/red(+) blk/red (-)*
FL = wht/blu(+) blk/blu (-)*
RL = yel/blu(+)yel/blk(-)
RR = yel/red(+)yel/grn(-?)

*NOTE: the "front" speakers are setup by the factory in a 4 speaker configuration, (parralelled to equal 4 ohms)so that will explain the double wires. -If you plan on changing out any of the front speakers, then this will affect the impedance (any aftermarket replacement speaker for the front is 4 ohms)... you will need to either disconnect the 4" dash speakers in order to run new door speakers, if not then the deck will 'see' a 2ohm load and it will get hot and shut down -lemme check @ work tomorrow and I can get the rest of the wiring color code... Hope this helps

[Eben]

almost forgot to mention, all of the front speakers (OEM's) are 8 ohms (1G's)

[hardlydangerous]

I know what your goin' through I had the same problem ,I found the power wires,and the ground with a multi meter,but had a hard time finding the rest of the front wires and where they went,also,the stock wires looked weak and brittle so I replaced all the wires to all the speakers,you can by universal main electrical harness plugs from 5 prong to 30 prong from most automotive stores or electronic stores like Raidio Shack,krimp on your own wires and you make your own wire harness,because I was goin to install an amp or two I went with 12 gauge wire for the 6 main speakers,and 4 gauge for the power wires to the amps,