what cams for fp red

[AWD_XTC]

I am thinking about putting and fp red on my car. The motor has grp aluminum rods and the head id fully built. The car can easily rev to 10,000 rpm. I was thinking maybe gsc s3 cams but i am looking for suggestions.

[phunny]

Originally Posted by AWD_XTC

I am thinking about putting and fp red on my car. The motor has grp aluminum rods and the head id fully built. The car can easily rev to 10,000 rpm. I was thinking maybe gsc s3 cams but i am looking for suggestions.

I currently have the FP 3x cams and I plan in to switch to the gsc s3 cams so I believe you are making a great choice. I'm also on a FPred.

[AWD_XTC]

Do you have the old red or the new hta red? What kind of power are you making?

[phunny]

Old red, over 600awhp

[AWD_XTC]

Great..thats what im looking to make. What size injectors what intake manifold etc

[phunny]

Bolt-on Modifications:
FPRed turbocharger Dynamic 2200CC injectors Tial wastegate & BOV SS exhaust header JMF aluminum intake manifold 3” throttle body -6AN fuel lines with Aeromotive AFPR3” turbo-back exhaust LC1 wide-band O2 sensor EGT, boost and O2 gauges on A pillar Battery relocated to trunk Oversized aluminum radiator with dual spal fans FMIC with 3'' piping Dual walboro 255lph fuel pumps(1 internal, 1 external) Evo III Oil Filter housing Mishimoto 19 Row External Oil cooler

Engine Management:
DSMLink v3 Electronic boost control solenoid 3.3-bar map sensor

Engine Internals:
2.3 Stoker, Weisco 9:1 piston, Eagle rods, ACL race bearings Eagle 100mm crank 1mm super tech valves, FP 3x cams everything's balanced

Drivetrain Modifications:
Built tranny with double syncros and a taller 5th gear ACT 2900 with sprung 6 puck Magnus's Launch Control Device

Suspension Modifications:
Tein lowering springs and shocks Front strut tower brace 17” Kosei (lightweight) wheels with 235/45R17 Toyo Proxes RA1 tires Wilwood 4 piston rotors

[AWD_XTC]

E85?

[phunny]

yup