I am in the process of installing the energy suspension kit for my rear suspension and have come down to the control arms with the offset sleeve. I have pressed out the inner and outer sleeve and installed the new energy suspension sleeve. But I have ran into a problem. When installing the sleeve per energy suspensions instructions I get the end result of the metal sleeve moving around. As shown in the following video:
https://www.youtube.com/watch?v=gW6bAmRdytg
I have searched this forum, dsmtuners.com and a few other places as well and there has not been one person that has this issue other than the youtube video I found. Does ANYONE have a possible answer or solution to this problem? This control arm has completely halted my build and is keeping me from getting the car back on the ground.
https://www.youtube.com/watch?v=gW6bAmRdytg
I have searched this forum, dsmtuners.com and a few other places as well and there has not been one person that has this issue other than the youtube video I found. Does ANYONE have a possible answer or solution to this problem? This control arm has completely halted my build and is keeping me from getting the car back on the ground.