DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner

6 bolt turbo to NT manual tranny ?

2K views 5 replies 3 participants last post by  2LiterRiceEater 
#1 ·
Ok , done some reading but like always I have questions.

I have a NT 2.0 6 bolt motor with a manual tranny. Now I want to put the NT tranny on it but cant remember if the NT tranny will fit over the turbo clutch and flywheel.

Will the NT tranny fit? I think at one time I tried to change years ago on another car but the NT bellhousing was not deep enough for the turbo flywheel where the fingers that the clutch bolts to.

Thanks in advance for any info.
 
#5 ·
Turbo clutches are larger, and are stepped from the PP mounting surface to the clutch disc friction surface. NT clutches have the PP surface at the same level as the clutch disc. The flywheel is also physically larger diameter which is why it doesn't fit inside the NT bellhousing and the bell housing provisions for the starter need to match it's intended flywheel for the starter bendex gear to mesh correctly.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top