Short Shifter

[nautical2086]

Does anyone here have this short shifter?

http://cgi.ebay.com/ebaymotors/OBX-S...74734683QQrdZ1

It says how much the throw is reduced but what about the height?

[HIDDEN_SUN_GST]

if its not shorter cut and weld

[nautical2086]

lol, i'm shopping for a short shifter that is about 2"s shorter, I've searched on this board for that but the result I keep getting is how to install them, and shorter throw, Anyone can help me out?

[RippinGSX]

The height should be lower as well. Most every one I have seen is lower.

[nautical2086]

yeah this I know, what I wanan know is how much lower.

[HIDDEN_SUN_GST]

Originally Posted by nautical2086

yeah this I know, what I wanan know is how much lower.

cant hurt to ask the seller?

[nautical2086]

never thought about that lol.

[MacGSX]

try looking for the B&m knock off, its like 60 bucks and it looks.works perfect. no complaints.

[nautical2086]

how much shorter is it than stock?

[RippinGSX]

Mine is about a half inch shorter top to bottom but that's not what's important here, it's how much shorter the throw is. Mine does not throw anywhere near as far back as the stock shifter did. I would say it cut at least an inch out of the back throw for sure.

[nautical2086]

that sounds good, i'm looking for shorter throw and about 2 inches shorter than stock.

[RippinGSX]

It's not going to be 2" shorter top to bottom. Get a shorter shift knob. Do you wan't me to take a pic of mine for you? Mine is the B&M as well.

[nautical2086]

sure, lets see it.

[RippinGSX]

I'll snap one tommorow when I get home from work. I get off at 8pm so remind me. Might be able to do it before I go in.

[nautical2086]

alright