DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
593 Posts
Discussion Starter · #1 ·

·
Registered
Joined
·
532 Posts
Well you could get the Eagle Rods, Mahale pistons and ARP main studs for about $700-$850, I would get the parts then get it machined and put it together my self.
 

·
Registered
Joined
·
593 Posts
Discussion Starter · #3 ·
How much does machining run? How much do you think I'd save?
 

·
Registered
Joined
·
532 Posts
I just got a block done not to long ago .10 and hot tanked and paid about $275. I know the guy that did it so i got a hook up and hes got a giant shop at his house. Just call around and see what some shops say.
 

·
Elite DSMtalker
Joined
·
2,617 Posts
Machining should be $500 minimum figuring hot tanking, magna fluxing, boring, honing, etc,... Now price out all the parts you'd need, and that'll give you an idea how much you'd save on the purchase. Next consider your level of skill, and their experience, and decide for yourself what that's worth (add in the cost of extra tools and gauges too).
 

·
Registered
Joined
·
66 Posts
I personally know Bill the owner at showdown and they are good people and the price is not bad plus you know they build them right because they built there race car motor!

Just give him a shout and talk to him what you want!

Just my $.02
Turbo
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top