Balance Shaft eliminator q's

610 Views 3 Replies 4 Participants Last post by shawnES, Dec 12, 2005

talonandyotas

Discussion Starter · Nov 11, 2005

Ok So the front balance shaft has two bearings I need to remove, to do the eliminator kit. Can I get those two bearings out and in without pulling the whole motor out of the car? What have you guys done?

Save

1 - 4 of 4 Posts

MitsuModder

· #2 · Nov 11, 2005

you can get them out if you undo the motor mounts to allow the motor(timing end) to hang at enough of an angle. it has been done.

Save

Silver TSI

· #3 · Nov 11, 2005

Even on the angle, I couldn't get the balance shaft out. I had to cut it in half with a hacksaw.

Save

shawnES

· #4 · Dec 12, 2005

i was able to pull out the balance shaft in my 94 ES by unbolting the bottom motor mount and letting the engine down with a floor jack...

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month