DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
729 Posts
Discussion Starter · #1 ·
These questions have probably been answered a million times over, but i havn't seen them yet so here goes.

I think i am going to get a "big" 16g. I have a couple of questions though. first off I already have a ported 6cm housing from my 14b. What would happen if i put this smaller housing on the 16g. Certainly it would spool faster, but are there any negative effects that would happen?

second, would the increased flow of the big 16g combined with the 6cm housing cancel the increased lag of the big 16g over the regular 16g while still maintaining and equal or better peak hp output?

The more technical information on this subject you can give me the better. thanks


[This message has been edited by gsxalex (edited August 17, 2000).]
 

·
Registered
Joined
·
5 Posts
yes it will give you faster spool at thecost of top end.i ran a 12.8 with a small 16g clipped/ported in a nearly stock car.
 
1 - 2 of 2 Posts
Top