DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 2 of 2 Posts

107 Posts
Discussion Starter · #1 ·
Most parts have surface rust from sitting, wipes off easily with a green wool pad.

Revhard T4 manifold w/ knock off wastegate, missing banjo & fitting never used 300+ ship

Turbonetics T4 60-1 Hi-Fi w/ ceramic ball bearings .81 AR on center housing O trim turbine wheel Used 1k 450 + Ship

Turbonetics T3 manifold never used 250+ ship

Downpipe back 3" mandrel exhaust w/ test pipe Never used 1g AWD 400 + ship

2.5" O2 housing 5 bolt ford flange 1G AWD New 50+ ship

2" I.D. TB elbow with external BOV mounted Used 50 + ship

Blitz FATT DCII Auto turbo timer New 100+ Ship

Venom 400 control module piggyback 90-94 Used 100 + ship

Long route FMIC (no piping) Used 100 + ship

1G 6 bolt short block needs 1 squirter and rod bearings, Ross 9:1 Pistons, .030, eagle h beam rods, arp main studs, clevite main bearings, ACT streetlite flywheel, used act 2600 400 mi, torque plate honed, balanced, hot tanked, new freeze plugs, balance shaft eliminator installed, minor surface rust from sitting. Never used or installed 1700 + ship

Paypal or money order no checks!!!!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.