DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 20 of 21 Posts

·
Registered
Joined
·
173 Posts
Discussion Starter · #1 ·
http://www.gadsm.org/showthread.php?p=609500#post609500


Above is a write up of the enclosure put in my 1g. I will be using an Alpine Type-R eventually, for the time being a Type-S. I will finish the write up within the week. I decided to track down a vinyl that matches the back quarter panels. I am a bit leary of painting since I will be using the trunk and do not want to damage it. Any constructive criticism is welcome.
 

·
Registered
Joined
·
39 Posts
dsmwookie said:
http://www.gadsm.org/showthread.php?p=609500#post609500


Above is a write up of the enclosure put in my 1g. I will be using an Alpine Type-R eventually, for the time being a Type-S. I will finish the write up within the week. I decided to track down a vinyl that matches the back quarter panels. I am a bit leary of painting since I will be using the trunk and do not want to damage it. Any constructive criticism is welcome.
hey can you put the pictures up on DSMTALK :)
 

·
Registered
Joined
·
173 Posts
Discussion Starter · #7 ·
Sorry guys but I cannot downsize the pictures enough to make them fit on this site.

Each of the pictures is about 250-450KB.

If someone wants to toss me an email address Ill send it so you can either resize or just see in general.
 

·
Registered
Joined
·
173 Posts
Discussion Starter · #9 ·
http://i14.photobucket.com/albums/a343/dsmwookie/DSC_0199.jpg


http://i14.photobucket.com/albums/a343/dsmwookie/DSC_0195.jpg


Here are two pictures sorry for the delay. Yeah sorry forgot I had a photobucket account from years ago. Can't post the whole write up though that is just time consuming. I am laying a matching Vinyl onto the box tomorrow. I decided against painting because I will be actually using my trunk. I felt that vinyl would last longer with less blemishes since I am not very delicate with things I just toss in the car.
 

·
Registered
Joined
·
173 Posts
Discussion Starter · #12 ·
Most likely an Alpine Type E. I am not a huge audio person and my funds generally go towards engine parts. I may upgrade later to an Alpine Type R but it just depends the Type E may satisfy me.

Ill get up pictures tomorrow of it after its vinyl wrapped. Btw the quarter panels I currently have are faded and scratched so those will be replaced within the week most likely. Not to mention re carpeting the actual trunk itself.
 

·
Registered
Joined
·
173 Posts
Discussion Starter · #13 ·

·
Registered
Joined
·
173 Posts
Discussion Starter · #15 ·
No, it was a good learning experience but their is no money to be made in this. I did this strictly because I wanted to know how for future endeavors and to provide myself with a clean installation. I may re-wrap it to get some unseen imperfections out :(
 

·
Registered
Joined
·
173 Posts
Discussion Starter · #20 ·
talentfinder36 said:
Another GA boy!! Looks good man. Wrappings a biatch ain't it? Good work though.


Mark -ABKS Motorsports
Yeah I thought it would be a lot easier. I may end up redoing it to get it to perfection.
 
1 - 20 of 21 Posts
Top