DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
430 Posts
Discussion Starter · #1 ·
Wondering if running a core w/ 2 inch inlet/outlet and using couplers to go to 2.25 inch piping would be a bottleneck?
I've got a core that is the size I'm looking for(14b/16g), except the outlets are smaller than the "norm".
 

·
Registered
Joined
·
430 Posts
Discussion Starter · #4 ·
Just as a reference, I've seen many posts say that it would be tough to notice a difference in spool time of 2.5" vs. 2.25"....
Couldn't this be related to a small pipe reduction?
 
1 - 4 of 4 Posts
Top