DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner

How to test EGT?

793 Views 1 Reply 2 Participants Last post by  g9s0x
My Greddy EGT died the other day. Short of buying a new probe or gauge, does anyone know how to test this to see which one is burnt out?

1 - 2 of 2 Posts
"The EGT probe produces a very low voltage, less than a volt, and it'll have to
be measured with a high impedance digital multi-meter."

I had a similar question a few weeks back and that came straight from Jon Ripple at TRE. I was troubleshooting a new probe that wouldn't work and my voltage readings were around 2 mV. Hope this helps you out.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.