DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter #1
I am rebuilding a '90-'91 4G63, and need to know the best location to secure it to an engine stand. I figure the bolt locations for the tranny bell housing, but if there is a better place, please let me know. Also, does anyone know what size bolts I should buy to use for mounting?
 

·
Registered
Joined
·
254 Posts
yes, you use the holes for the tranny, just like on any other engine. Take one of the bolts to a hardware store, and buy 4 of them to use on the stand. I dont remember the size, but it is a common metric thread.
 
1 - 2 of 2 Posts
Top