DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
299 Posts
Discussion Starter #1
I'm doing a turbo install on a 420A setup. Everything is installed except for the oil feed line. Can someone give me some good recommendations on where I should tap into? I know on my 420 it was installed on the rear of the block in the middle...an almost impossible place to get to unless you remove the intake manifold. I know there has to be easier places!!!

Thanks :D
 
1 - 2 of 2 Posts
Top