DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I can't seen to get the oil pump sprocket mark to line up dead on. It's about 1/2 a tooth off either way, all other marks are lined up. Will this affect anything if i leave it like this? or should i keep trying..PITA

Any suggestions would be much appreciated
 

·
Registered
Joined
·
140 Posts
i think it wont hurt anything. just make sure that your balance shaft is inline with your oil pump. do you know what i mean? Read the Vfaq to find out for sure. you have to remove this bolt on the back of your engine and put a screwdriver in there to see if its ok. good luck man! other than that...it should be just fine.
 
1 - 2 of 2 Posts
Top