Just wondering if any of you guys that have a MAFT setup in your 1st gen along with an atx. What are your trim setting cuz mine are all crpped out and cant figure out how to tune it. Help would be appreciated.
What setting for an 94 ATX with a MAFT/maf setup
Venom55
1 - 3 of 3 Posts
Hey Pat maybe I can help you a bit..Its me the guy that bought your valve cover..
I have a maft and maf too.I have 650 injectors though.
I would think you could set it zero on all the dials and set the injector size to the recommended for starters.Then just lean out wot a little bit if you are getting fuel cut and lean out mid a little bit and usually you have to raise idle up a notch or two.
You have no logger???.I tried tuning my car lately but my o2 sensor does not want to read higher than .83 or so no matter where I set it.Its a new sensor but did find the muffler shop left off my ground strap on my exhaust so just one put back on but now car is dead in the shop for fubared wheel bearing that wiped out tons of stuff on back end.
Will try to tune as soon as get it back and try new 02 even though it is new if my o2 don't read past .90 when richened up.
Anyway your car if it has stock injectors should start and run not too bad with the other dials except base zero.Although it might be touch doggy.
I have a maft and maf too.I have 650 injectors though.
I would think you could set it zero on all the dials and set the injector size to the recommended for starters.Then just lean out wot a little bit if you are getting fuel cut and lean out mid a little bit and usually you have to raise idle up a notch or two.
You have no logger???.I tried tuning my car lately but my o2 sensor does not want to read higher than .83 or so no matter where I set it.Its a new sensor but did find the muffler shop left off my ground strap on my exhaust so just one put back on but now car is dead in the shop for fubared wheel bearing that wiped out tons of stuff on back end.
Will try to tune as soon as get it back and try new 02 even though it is new if my o2 don't read past .90 when richened up.
Anyway your car if it has stock injectors should start and run not too bad with the other dials except base zero.Although it might be touch doggy.
Joined
·
25,879 Posts
What kind of monitoring equipment are you using?
Read through the MAFT threads on this board. The adjustment and tuning methods will work just the same for you even though your are automatic.
Read through the MAFT threads on this board. The adjustment and tuning methods will work just the same for you even though your are automatic.
1 - 3 of 3 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
