DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
241 - 260 of 577 Posts
they arent that bad, I've driven an hour in them, its wasnt the most comfortable but its do-able. However I do not have the covers which actually help ALOT. I think summit has a deal that its $60 or $70 for the seat with the cover.
 
Almost done the fuel cell, just have to run the new lines and remove the stock equipment. Car was under 2700 with me before the fuel cell, headlights, radiator, and odyssey battery. Once I finish with the gas tank, rear floor, rear glass and CF hood, I hope to see around 2500 w/driver.

Image

Image
 
Is that for your fuel system? I was intending to mount a 1 gallon fuel cell I have in the exact same location for my alky setup I will be doing.
 
16g-95GSX said:
Is that for your fuel system? I was intending to mount a 1 gallon fuel cell I have in the exact same location for my alky setup I will be doing.
I'd just utilize the stock windshield fluid bottle..I think it'd look alot cooler to use a 1gal cell but in the end you're still paying for the cell and if you're like me you don't use your wiper fluid anymore so why not..Plus when it runs low you have a stock indicator light installed already.. :)
 
4SFED4 said:
Nice install...
Is that a 1gal cell??
I've had thoughts of downsizing to a 5gal cell, but 1gal would hender my street fun too much.
Thanks, yes its a 1 gallon cell. The car definately wont be driven on the street anymore. I figured by dropping the stock tank and lines and the rear floor, i should save about 50lbs or so? Ill weigh it all when Im done.
 
A fuel cell replaces your gas tank. They come in different sizes. 5 gal, 1 gal, etc.

Used to complete a fuel system. You don't need a 15 gal tank when you drag racing
 
Originally Posted by turbo8765
Is there a vendor that has a fiberglass panel that I can install in place of the sun roof glass??

Just searching in the NC area this place may be able to help;

International Fiberglass • 1101 B St. • New Bern, N.C. 28560 • 252-634-336
http://www.intl-fiberglass.com/index.html
 
I thought about removing the headlight assembly as well..The motors along with the sealed beams have to weigh a little..Scap,how did you do yours?..Did you just put bulbs behind the clears?..
 
241 - 260 of 577 Posts