DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
1 - 9 of 9 Posts

jordantalon95

· Registered
Joined
·
123 Posts
Discussion starter · #1 ·
I just had a question about the transistor pack.

I just tested the resistance of each injector and they read 2.7 ohms then tested with a 12 volt power supply and got the clicking sound. Which I never got when i was cranking so now I suspect the Injector transistor pack.

I was wondering is there a fuse or relay that controls this part as I wanted to check before I change the pack.

Thanks, Jordan
 
Discussion starter · #6 ·
Sweet,
I had to drive all the way to Buffalo to get this resistor pack but as soon as I got home put it in cranked that puppy and it started up no problem.

I just want to say thanks for all the insight and help that was given to me on this forum I would've never been able to do it without all the good guys on DSM talk.

Thanks, Jordan
 
Discussion starter · #8 ·
Yeah you should keep them because the dealer doesn't make them anymore or just send them to me.

All I had to do to figure out it was the Injector Resistor Pack was read the Hayne's manual on fuel systems.

-Then I checked to make sure i have a good spark
-Check if gas was getting to the fuel rail
-Checked the wires going to the injectors with a node light didn't flash. Although when i used a test light i had power but no ground.
-Then checked the ECU visually for damage looked alright.

So I thought this could be the only problem changed it and so far so good.
 
1 - 9 of 9 Posts