DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
Cancel
Create thread New Garage Forums

Pulling the compresser wheel...

Jump to Latest
1 - 2 of 2 Posts
T

t.otalondrvr

· Registered
Joined
·
174 Posts
Discussion starter · #1 ·
Anything I should know about before I start hacking at this turbo i have sitting here?,

I have a mint 60-1 here that just needs a new inlet wheel...

I want to pull the wheel off so i can get the supposed part number from the inside and buy a new one...

Then get it re-balanced and mount it up.

Is it only the bolt that you look at through the compressor housing that needs to be removed?, to get the wheel off..

Thanks in advance.
 
Discussion starter · #2 ·
Somebody might already know what wheel what I need...

It's a Turbonetics 60-1 with a stg5 .63A/R exhaust housing and "Big Shaft" upgrade...
54mm/ish inducer and 79mm/ish exducer on the inlet wheel and exducer on the exhaust wheel measures 62mm i think.

T3/T04e 3in Comp housing.

Thanks,
 
1 - 2 of 2 Posts
About this Discussion
1 Reply
1 Participant
Last post:
t.otalondrvr
DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum
posts
2.3M
members
104K
Since
2000
A forum community dedicated to Mitsubishi Eclipse, Plymouth Laser and Eagle Talon owners and enthusiasts. Come join the discussion about performance, turbos, builds, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General DSM Tech and Tuning Help! Tech Newbie Questions Forum Body Tech and Appearance Electronics Tech