DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
Cancel
Create thread New Garage Forums

Car vibrates like crazy with new carrier bearings

Jump to Latest
1 - 4 of 4 Posts
2

217talon

· Registered
Joined
·
96 Posts
Discussion starter · #1 ·
So I finally got the transfer case filled up and just took the car for a quick spin. The car vibrates worse then ever if I start to get above 25 mph! I also installed a DME camber kit. I pressed the new ones on and they were straight. This car is beginning to be a ******* joke again!

Any Ideas?
 
#2 ·
IF this is a driveline vibration from replacing the carrier bearings, Did you reinstall the carrier bearing shims(washers) back in the correct location when you put the prop shaft back into the car?

Get a magnetic angle finder and check your driveline angles. The shafts should be sitting the same angles to one another. If not you'll need to shim the carrier bearings to get them to be the same.
 
#3 ·
Are you sure you replaced the drive-shaft in correct phase?
 
Save
Reply Quote Like Like
1 - 4 of 4 Posts
About this Discussion
3 Replies
4 Participants
Last post:
dsm2gnick
DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum
posts
2.3M
members
104K
Since
2000
A forum community dedicated to Mitsubishi Eclipse, Plymouth Laser and Eagle Talon owners and enthusiasts. Come join the discussion about performance, turbos, builds, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General DSM Tech and Tuning Help! Tech Newbie Questions Forum Body Tech and Appearance Electronics Tech