DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum banner
Cancel
Create thread New Garage Forums

rattling noise after b-shafts removed

Jump to Latest
1 - 2 of 2 Posts
J

jd1828af

· Registered
Joined
·
502 Posts
Discussion starter · #1 ·
i removed the balance shafts a few days ago and now im getting a loud rattling noise comming from the passenger side of the engine. i only get it above 4k rpm and i know it is not a heat shield. the only thing i could think of is one of the rear b-shaft bearings fell out and is rattling around in the oil pan. not sure if that i possiable but i have no idea where to start looking.
 
#2 ·
Im getting a ticking that follows rpm no matter what RPM, but i think mine is something in the oil pump since i just cut the rear shaft off. Did you leave in the front shaft and bearings? I left mine in to save on the headache but its possible your front bearings fell out.

my_gst95
 
1 - 2 of 2 Posts
About this Discussion
1 Reply
2 Participants
Last post:
my_gsT95
DSMTalk Forums: Mitsubishi Eclipse, Plymouth Laser, and Eagle Talon Forum
posts
2.3M
members
104K
Since
2000
A forum community dedicated to Mitsubishi Eclipse, Plymouth Laser and Eagle Talon owners and enthusiasts. Come join the discussion about performance, turbos, builds, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General DSM Tech and Tuning Help! Tech Newbie Questions Forum Body Tech and Appearance Electronics Tech